Request AudioReQuest N.Series Información técnica descargar pdf (Pagina 11)

Phone (518) 899-1254 • Fax (518) 899-1251 • www.request.com

7 -

Adding AudioReQuests

The Multi Zone program is designed in such a way that adding more AudioReQuests to the program is as

simple as possible.

1. Select the S-1.5 : {ARQ_01} subsystem and press Ctrl-C on your keyboard.

2. Select the S-1 : AudioReQuest Logic folder and press Ctrl-V to paste.

3. Select the newly copied subsystem and press F9 on your keyboard.

4. In the Search and Replace dialog box, replace all instances of ARQ_01 with ARQ_02.

a. If you already have an ARQ_02 folder, use the next available number.

5. Click OK.

If you are adding an F4.Series unit (4 Zone box), skip to step 10 below. Otherwise, continue.

6. Open the S-1.6.1 : Ethernet OR Gates subsystem

7. Open all 3 gates into detail view by double clicking on each one.

8. If the unit you are adding is a 2 zone box (F2.Series):

a. Remove the last 2 input/output pairs on each gate

b. Comment out the S-1.6.4 : {ZONE_03} and S-1.6.5 : {ZONE_04} subsystems

9. If the unit you are adding is a 1 zone box (N.Series, Fusion, Nitro, etc):

a. Remove the last 3 input/output pairs on each gate

b. Comment out the S-1.6.3 : {ZONE_02} through S-1.6.5 : {ZONE_04} subsystems

c. If the unit you are adding is running firmware earlier than 2.1.0:

i. Open the S-1.6.2.1.1 : ARQConnect… module into detail view

ii. Scroll to the bottom of the module and change the Zone number from 1 to 0

10. If desired, open every ARQConnect module and modify the [ZONE_NAME] parameter to

something more descriptive for your install.

The next step is to add the ARQ-CONNECT signal to the Connection Interlock:

11. Open S-1.4.1.1 : Interlock into Detail View

12. Select the last line on the input side and press Alt-‘plus’ once for each AudioReQuest Zone you

have added to the system (4 times for one F4, 2 times for one F2, etc)

13. Select the last line with a signal name on it and press Ctrl-C

14. Select the first empty line and press Ctrl-V. This will copy the ARQ-CONNECT signal to the new

line.

15. Change the ARQ_XX and ZONE_XX numbers appropriately.

16. If the unit you are adding is a F2 or F4, select the remaining lines and press F4 on the keyboard.

This will copy the signal name to the remaining lines and automatically increment the ZONE_XX

number.

17. Do the same for the output side of the interlock

18. Repeat the above steps for the interlock in each Panel_X folder

Figure 8a

Figure 8b

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Sin comentarios

Request AudioReQuest N.Series Información técnica Pagina 11